Use instead of your speed controller's built-in BEC when you need more current than the built-in BEC supplies. This unit can supply up to 3 amps continuous from up to 23V (5S Lipo) of battery power. Switch-mode DC-DC conversion is highly efficient and doesn't heat up like regular linear BECs.
The output connector plugs into the battery connector socket on your receiver. The input wires must be spliced into your speed control battery wires. If your speed controller has a built-in BEC, it must be disabled. Some controllers have a jumper for this, while others will require you to cut or remove the pin from the connector housing for the red wire on the speed controllers servo cable. Comes with noise trap built into the wire leads.