Higher resolution

The tightest dead band

Accurate positioning

Faster control response

Quicker acceleration

Constant torque throughout the servos travel

Increased holding power when stationary

The servo comes with an accessory package and the universal JR/Hitec "S" Connector which is physically and electrically compatible with all major receiver brands sold worldwide. Servo leads are eight inches long from case to end of plug. Follow the wiring diagram below. If you hook the servo up incorrectly nothing bad will happen - just flip the S connector around and the servo will work correctly.

"S" Type Connector	Futaba "J" Connector	Wire Info
Brown Wire	Black Wire	Battery Negative
Red Wire	Red Wire	Battery Positive
Orange Wire	White Wire	Signal

WARNING: Using the servo arm to turn the servo motor may cause the gears to break or jump and the servo will stop functioning correctly. This is true for all servos regardless of servo manufacturer. BP Hobbies assumes no responsibility once this kind of damage. This can also occur as a result of crash damage or hard landing. Once you install and use a servo BP Hobbies assumes no responsibility any damages that may occur.